When I export a channel- csv, it has the following columns:
Zone,CH Num,CH Name,RX Freq,TX Freq,RX TS,TX TS,RX CC,TX CC,Type,Power,Bandwidth,RX Only,Contact Name,RX Group Name,Scan List Name,Alarm,Prompt,PCT,MSG Type,TX Policy,EAS,TX Tone Type,TX Tone,RX Tone Type,RX Tone,APRS CH,Relay Monitor,Relay Mode
I am missing "DMR-Mode" (simplex or Dual Slot). Is this a bug, or do I overlook something?
I have heavy errors making new zones and putting digital channels into them.
None of these work with reepeaters, except those zones, which were already in the radio.
The new groups show the DMR Mode in CPEdit and You can edit them. But in later the GD-88 there is only one TS which behaves strangely:
You can toggle a "TS1"-entry to "TS2", but after this it stays on "TS2"; you have to cancel the editing and start over again, if You want to change it again.
Once saved as "TS2", it never can be changed vack to "TS1"
This feels like a firmware bug - or is it possible to be caused by a bug of CPEdit, which leaves out the DMR Mode field?
The factory zones/channels have a "Dual Slot" Entry in the radio, which can be changed to "simplex" and vice versa, as well as they do have two TS-fields.
The channels which were generated by CPEdit, do not have a DMR Mode choice and they have only one TS-entry which behaves weird as described above.